Register to post in forums, or Log in to your existing account
 

Post new topic  Reply to topic     Home » Forums » zExplorer Discussion
Lila_AC
Newbie


Joined: 18 Jul 2004
Posts: 8

PostPosted: Sun Jul 18, 2004 1:43 am   

AC Explorer thinks I leave a corpse when recalling
 
When I house recall or mansion recall, a corpse appears on the map.

I'm running v3.33a and ACX Server 1.30.0.0, playing on Morningthaw with calibration settings in the July patch calibration thread.

Do I have something set incorrectly? I don't recall this happening last month, but I wasn't paying attention much either.
Reply with quote
Zugg
MASTER


Joined: 25 Sep 2000
Posts: 23377
Location: Colorado, USA

PostPosted: Sun Jul 18, 2004 4:17 am   
 
That's normal. If the program sees your location jump by a large amount and you were not at the start of a known portal, then it thinks you have been portalled due to dying and leaves a corpse.

It's been a while since I looked at this, but I *think* that if the portal location is stored in one of your custom portal definitions, then it won't leave a corpse. So, try to define a custom portal command in AC Explorer for your house and mansion locations.
Reply with quote
Eshvanu
Newbie


Joined: 18 Jul 2004
Posts: 4

PostPosted: Sun Aug 22, 2004 2:14 pm   
 
...and get used to occasionally going to Full view, then clicking Tracking -- Clear all corpses. I consider that action as part of maintaining the software.
_________________
Killing Drudges on FF for more than 3 years
Reply with quote
Display posts from previous:   
Post new topic   Reply to topic     Home » Forums » zExplorer Discussion All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
© 2009 Zugg Software. Hosted on Wolfpaw.net