 |
Lila_AC
Newbie
Joined: 18 Jul 2004
Posts: 8
|
 Posted: Sun Jul 18, 2004 1:43 am
AC Explorer thinks I leave a corpse when recalling
|
When I house recall or mansion recall, a corpse appears on the map.
I'm running v3.33a and ACX Server 1.30.0.0, playing on Morningthaw with calibration settings in the July patch calibration thread.
Do I have something set incorrectly? I don't recall this happening last month, but I wasn't paying attention much either. |
|
|
|
|
Zugg
MASTER
Joined: 25 Sep 2000
Posts: 23379
Location: Colorado, USA
|
Posted: Sun Jul 18, 2004 4:17 am
|
That's normal. If the program sees your location jump by a large amount and you were not at the start of a known portal, then it thinks you have been portalled due to dying and leaves a corpse.
It's been a while since I looked at this, but I *think* that if the portal location is stored in one of your custom portal definitions, then it won't leave a corpse. So, try to define a custom portal command in AC Explorer for your house and mansion locations. |
|
|
|
|
Eshvanu
Newbie
Joined: 18 Jul 2004
Posts: 4
|
Posted: Sun Aug 22, 2004 2:14 pm
|
...and get used to occasionally going to Full view, then clicking Tracking -- Clear all corpses. I consider that action as part of maintaining the software.
|
|
_________________
Killing Drudges on FF for more than 3 years |
 |
|
|
|
|
|
