Zugg Software :: View topic

Posted: Wed Nov 04, 2009 9:45 pm

I have three seperate zones in the mapper which correspond to three seperate areas on my mud. All three have exits whose destination is the same room in a fourth zone.

Ie,

GURU Joined: 23 Dec 2000 Posts: 4834 Location: USA

It's easy, but tedious. Essentially, it's just one normal up-down pair along with 2 one-way down exits.

1)take note of D's room number
2)from D, go UP to A to create A. Go back down to complete the process.
3)navigate to B (you can do this via the mapper, rather than actually moving your character there, if you already have it mapped)
4)on the Exits Tab of the Room Properties window, right-click on the table with the list of exits and select New Link
5)with this new link highlighted, press the # button and assign D's room number (the To field should then show D's name, and possibly will draw a link line to Room D's location).
6)press the One Way button to remove the corresponding exit from D.
7)Press the Down button in the From compass to assign it to this link (the down arrow next to the room box on the map will then appear).
8)go back to step 3 to repeat the process for C

Posted: Wed Nov 04, 2009 11:16 pm

You're my hero, thanks Matt. I didn't realize you could just link to any arbitrary room number with that dialog :)

Anyway, works great. Thanks again.