Register to post in forums, or Log in to your existing account
 

Play RetroMUD
Post new topic  Reply to topic     Home » Forums » zMUD General Discussion
Gruzzen
Newbie


Joined: 30 Jun 2006
Posts: 1
PostPosted: Fri Jun 30, 2006 2:22 pm   

Triggers and #Echo
 
Greetings!

I am running some triggers that fire off of some #Echo commands that Other triggers send to the Mud.

I have one trigger that fires exactly one time. I have other triggers that trigger off of other #Echo commands and they fire every single time. If I close Zmud and open it back up, the trigger will fire again. If I type into the command prompt the Trigger pattern the trigger will fire. If I type "#Echo TriggerPattern" into the command Prompt (without quotes) then the trigger will fire.

Yet, the trigger will only fire one time when another trigger executes the #Echo command. The command is getting echoed to the screen. Checking my settings editor the trigger is still enabled.

What am I missing?
Reply with quote
TonDiening
GURU


Joined: 26 Jul 2001
Posts: 1958
Location: Canada
PostPosted: Mon Jul 03, 2006 3:30 am   
 
I am unclear what is not working.

Sounds like you should be calling alias's versus echo'ing and triggering on triggers?
Reply with quote
Display posts from previous:   
Post new topic   Reply to topic     Home » Forums » zMUD General Discussion All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

© 2009 Zugg Software. Hosted by Wolfpaw.net