 |
tvm001
Beginner
Joined: 11 Jun 2004
Posts: 16
Location: USA
|
 Posted: Fri Dec 30, 2005 1:51 pm
Mapper stops mappping?
|
My mapper has stopped mapping new rooms. I have reconfigured and created new rooms with each new reconfiguration, but no new rooms will be created in the normal map creation mode. Any suggestions? Note that map following works. Thank you in advance for any help. I am running version 7.20a
|
|
|
|
|
Tech
GURU
Joined: 18 Oct 2000
Posts: 2733
Location: Atlanta, USA
|
Posted: Sat Dec 31, 2005 7:19 am
|
Well map following and map creation are two different modes, so one won't affect the other. Very likely your mapper descriptions have changed and are not creating the new room. I would also review the manual configuration of the settings.
|
|
_________________
Asati di tempari! |
 |
|
|
tvm001
Beginner
Joined: 11 Jun 2004
Posts: 16
Location: USA
|
Posted: Sun Jan 01, 2006 7:00 pm
|
| Tech wrote: |
| Well map following and map creation are two different modes, so one won't affect the other. Very likely your mapper descriptions have changed and are not creating the new room. I would also review the manual configuration of the settings. |
Asati, thanks for the suggestion. I went back and rechecked my mapper configuration but did not find anything there, but in the general preferences of zmud configuration, I had turned on MXP for some reason. When I disabled MXP, the mapper started working again.
I appreciate the help.
Regards,
TVM001 |
|
|
|
|
Tech
GURU
Joined: 18 Oct 2000
Posts: 2733
Location: Atlanta, USA
|
Posted: Mon Jan 02, 2006 11:28 pm
|
No prob... happy to help.
I'm guess that your MUD is probably using some MXP or XML tags under the covers that were causing the hiccup. |
|
_________________
Asati di tempari! |
|
|
|
|
|
|
