 |
devyndraen
Newbie
Joined: 05 Nov 2005
Posts: 1
|
 Posted: Sat Nov 05, 2005 5:49 am
Mapper does not open new doors
|
When moving into a new room, I add any door (with #DOOR <dir>) to the exits of the room. When I try to go in the direction of a door that has just been created, and does not have a room attached to that exit yet, the mapper does not issue the "open <dir>" command.
In order to get it to issue the command, I must open the door myself, move into the new room, move back to the old room (in which it does not issue the open command either!), then it will issue the command at any future time.
Is there some command I need to perform to enable the mapper to issue the open command on a one-way link?
-Devyn |
|
|
|
|
Tech
GURU
Joined: 18 Oct 2000
Posts: 2733
Location: Atlanta, USA
|
Posted: Mon Nov 07, 2005 2:58 am
|
Open the mapper... go to Config --> Configuration Settings... In the Map Preferences select on the Strings and Doors option... you can then specify the commands to send when you open the door and open a locked door.
That should do the trick. |
|
_________________
Asati di tempari! |
 |
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
