mjfjr
Newbie
Joined: 06 May 2004
Posts: 1
Location: USA
|
 Posted: Thu May 06, 2004 5:56 am
Mapper config problem
|
I run automapper and it identifies everything perfectly. Then when I move normally (outside of the automapper config), the mapper grabs
[Start Automapper config]
e
>e
Terminus <<-- Recognized as Name of Room by Automapper
This is a circulation area within the terminus. Huge signs hang in mid-air - apparently of their own volition - pointing east, south and west. The east sign says 'EXIT'. The south sign says 'ENTRY' and the west sign says 'SHIPS.'<<-- Exits okay
[Automapper config closes, enter e normally]
e
>e <<-- Now this is listed as the Room Name, exits are ID'd okay
Terminus exit
You are standing in the terminus exit area. The exit is to the east - and because it's a one way system, that's the only way you can go!
How can I get the mapper to find the room name correctly? |
|
