 |
RobMacAF
Apprentice
Joined: 09 Jun 2002
Posts: 186
Location: USA
|
 Posted: Sat Jun 07, 2003 9:37 pm
Mapper question
|
I got my city map done and it works nicley but I have ran into a small problem. I wanted to add the guilds that are in the city so I took one of the smaller ones and made it into a new zone but I can't link them. I have the link made between them but to enter the guild it is Go Door and to leave it the command is Out. The problem I have is it seems the link option Other makes both of the exits the same other term. So I could have both exits as go door or both as out. But I need one to be out and one to be go door. Is there anyway to do this?
|
|
|
|
|
Kjata
GURU
Joined: 10 Oct 2000
Posts: 4379
Location: USA
|
Posted: Sat Jun 07, 2003 10:17 pm
|
Once you create the exit of type other, edit the Properties of one of the rooms and put the correct command for the exit in that room. The go to the other room and put the correct command in that one. I have no problem doing this.
Kjata |
|
|
|
|
RobMacAF
Apprentice
Joined: 09 Jun 2002
Posts: 186
Location: USA
|
Posted: Sun Jun 08, 2003 12:09 am
|
Seems I was making it harder then I should have been. One last thing. When you connect zones it puts a label of where it goes. Is there anyway to make that smaller or turn it off completely? Thank you so much for the help
|
|
|
|
|
Kjata
GURU
Joined: 10 Oct 2000
Posts: 4379
Location: USA
|
Posted: Sun Jun 08, 2003 1:42 pm
|
You can't make it smaller, but you can turn it off. Edit the Properties of the room you want, select the correct Exit and uncheck the Draw Link option.
Kjata |
|
|
|
|
|
|
|
