Zugg Software :: View topic

Newbie Joined: 07 Nov 2001 Posts: 2

ok, I downloaded zMUD off the site, then after it was done downloading and it was ready to install there was a pop-up message that said "failure to initialize installation [CRC] paramater was incorrect" then it exited out of the installation. I tried downloading a few more times but it still didn't work. Any advice? (and this is my first time downloading zMUD in case that's helpful)

If the whole point of climbing mount everest is because it's hard...then why do people do it on the easy side? - George Carlin, "Napalm and Silly Puddy"

GURU Joined: 24 Sep 2000 Posts: 1237 Location: USA

Since there are two versions currently on the download page, could you specify which version you downloaded and tried?

I've downloaded 6.16 in the past without problems, and I downloaded 6.22 this morning without a hitch as well (meaning both have installed correctly).

If you downloaded via a program like GetRight, try downloading without it. If you downloaded without it, try it once with.

zMUD 6 Online Help: All the power you'll ever need.

Newbie Joined: 07 Nov 2001 Posts: 2

Thanks for the tip. I probably would have tried it sooner or later, but I forgot I even had a downloading program thing. Well , it worked, and it was v. 6.16. Thanks again =)

If the whole point of climbing mount everest is because it's hard...then why do people do it on the easy side? - George Carlin, "Napalm and Silly Puddy"