 |
scorapntula
Newbie
Joined: 21 Aug 2002
Posts: 3
|
 Posted: Wed Aug 21, 2002 1:11 am
Setting up a status window to capture info
|
I want a script that will capture the quest info that the quest master says and place it into a separate window. The problem I see is that the questmaster says the same thing to everyone (except the specific quest info) and I only want my quest info put in the window. The only different thing he says is "Thank you, brave (whoever) for accepting the quest" before he actually gives it.
Is there a way to use this line to turn the capture on and somehow turn it off after he finishes speaking?
Very Confused (you may be too),
Scorpantula |
|
|
|
|
Vijilante
SubAdmin
Joined: 18 Nov 2001
Posts: 5182
|
Posted: Wed Aug 21, 2002 1:38 am
|
#STW {%replace(@QuestInfo,"|",%cr)}
#TR {^Thank you, brave (%w) for accepting the quest} {#IF ("%1"=%char) {#T+ QuestCapture}}
#CLASS QuestCapture {disable}
#TR {seek item (%w)} {#ADDITEM TempQuest {Seek "%1"}}
#TR {kill mob (*)} {#ADDITEM TempQuest {Kill "%1"}}
#TR {around location (*)} {#ADDITEM TempQuest {Near room "%1"}}
#TR {in zone (*)} {#ADDITEM TempQuest {In zone "%1"}}
#TR {time limit (%d)} {#ADDITEM TempQuest {Time limit %1, currently %time("hh:mm:ss")}
#TR {get ye hence or whichever of above was last one} {#T- QuestCapture;QuestInfo=TempQuest;TempQuest=""}
#CLASS 0
Now that is completely non-specific, but then your post was equally vague. Be happy I didn't just answer yes to the single question you asked. |
|
|
|
|
scorapntula
Newbie
Joined: 21 Aug 2002
Posts: 3
|
Posted: Wed Aug 21, 2002 2:24 am
|
>Be happy I didn't just answer yes to the single question you asked.
Oh, praise you and your answer mighty Vijilante |
|
|
|
|
scorapntula
Newbie
Joined: 21 Aug 2002
Posts: 3
|
Posted: Wed Aug 21, 2002 2:31 am
|
Thanks
|
|
|
|
|
|
|
|
