 |
orphean
Apprentice
Joined: 21 Oct 2008
Posts: 147
Location: Olympia, WA
|
 Posted: Sun Nov 08, 2009 4:05 am
Slowdown a Speedwalk?
|
zMud apparently had a mapper config option which let you put in an X millisecond delay between sending directions to the mud. I can't seem to find an equivalent in CMUD. I'm using Slow for the speedwalking and it still is a bit too fast for this IRE mud (Achaea) I'm trying out and it tells me 'Now, now, dont' be too hasty!' when trying to speedwalk with the mapper.
|
|
|
|
|
MattLofton
GURU
Joined: 23 Dec 2000
Posts: 4834
Location: USA
|
Posted: Sun Nov 08, 2009 5:29 am
|
not just directions, it delays EVERY single command entered. What you want is in Preferences on the General tab of the Scripting section. You should see a list of checkboxes, then a textbox with up/down arrows with a caption of "delay between sending lines", and under that is something about the default scripting language.
|
|
_________________
EDIT: I didn't like my old signature |
 |
|
|
GeneralStonewall
Magician
Joined: 02 Feb 2004
Posts: 364
Location: USA
|
Posted: Sun Nov 08, 2009 5:32 am
|
You might try something like:
#nodir
disable speedwalk
#alarm +1 {continue speedwalking} |
|
|
|
|
orphean
Apprentice
Joined: 21 Oct 2008
Posts: 147
Location: Olympia, WA
|
Posted: Sun Nov 08, 2009 5:44 am
|
| MattLofton wrote: |
| not just directions, it delays EVERY single command entered. What you want is in Preferences on the General tab of the Scripting section. You should see a list of checkboxes, then a textbox with up/down arrows with a caption of "delay between sending lines", and under that is something about the default scripting language. |
I completely missed this, thanks Matt. |
|
|
|
|
|
|
|
