 |
Yodous
Apprentice
Joined: 23 Jun 2004
Posts: 105
Location: Poland
|
 Posted: Mon Sep 21, 2009 8:57 am
[3.10a] Enable/disable class when connecting
|
Hi there.
I couldn't find any similiar topic so I'vre created a new one.
When I create some class and mark it as 'Enable class when connecting' nothing happpens when I connect to mud.
Think that this could be some error.
Best regards |
|
|
|
|
Yodous
Apprentice
Joined: 23 Jun 2004
Posts: 105
Location: Poland
|
Posted: Mon Sep 21, 2009 9:00 am
|
I found that when I first start the session, the option 'Enable class when connecting' runs as it should. But if i choose 'disconnect' from menu and then use 'reconnect' then it won't work.
I think it should. Am I right? |
|
|
|
|
Yodous
Apprentice
Joined: 23 Jun 2004
Posts: 105
Location: Poland
|
Posted: Mon Sep 21, 2009 9:20 am
|
Seems that the same "bug?" is with 2.37 version
|
|
|
|
|
Rahab
Wizard
Joined: 22 Mar 2007
Posts: 2320
|
Posted: Tue Sep 22, 2009 5:14 pm
|
I believe this is the behavior that has existed since Zmud.
|
|
|
|
|
Zugg
MASTER
Joined: 25 Sep 2000
Posts: 23379
Location: Colorado, USA
|
Posted: Tue Sep 22, 2009 6:34 pm
|
Rahab is correct. The "enable when connecting" is left over from zMUD compatibility issue.
The idea with "Reconnect" is that you are connecting to an existing session that has just been recently disconnected for a short time. You don't necessarily want to reset all of your scripts when you are reconnecting to an existing session on a MUD.
You need to put the scripts for enabling your class (like #T+ classname) in an OnConnect event. |
|
|
|
|
Yodous
Apprentice
Joined: 23 Jun 2004
Posts: 105
Location: Poland
|
Posted: Thu Sep 24, 2009 3:11 pm
|
Thx.
That was what I did - use onConnect event. |
|
|
|
|
|
|
|
