Zugg Software :: View topic - Having some problem with #SHOW in triggers

Newbie Joined: 05 Dec 2008 Posts: 3

This was working this morning (~12 hours ago) but now it is not.

#SHOW command in triggers does not seem to output anything unless it is preceeded by a #WAIT in the same trigger thread. This only works for one subsequent #SHOW only. If there are two #SHOW commands, the then even with #WAIT neither of them outputs to the session window.

I have tried restarting CMUD and the result is still the same. Replacing #SHOW with #SAY works, but since #SHOW was working before with no changes to the triggers, I feel as if #SAY will stop working at some point too.

And, #WAIT 100 is reported by the script debugger to wait some odd 45xx ms, but of course it doesn't actually wait that long. Nor does it wait even close to 100ms based on the time stamps in the script debugger window.

Posted: Mon Dec 08, 2008 2:27 pm

Which CMUD version are you using?

Also, give us the exact code you're using (XML is even better) because I'm not seeing any problem with #show in triggers.