Zugg Software :: View topic

Newbie Joined: 16 May 2002 Posts: 8 Location: Estonia

I'm using slowwalking in mud(#wal roomname or
doubleclick on room in mapper).

In every room i trigger word exits and send #ok, so mapper proceeds to next room.

Everything is working perfectly, but there's a problem when a zone change occurs during the walk.

Here's some output:
Nearing Northern Ithmia. (road)
Filling the firmament is a lattice of heavy grey clouds. You see exits leading
ok
east and southwest.
3149h, 2881m ex-sw
Nearing a river. (road)
Filling the firmament is a lattice of heavy grey clouds. You see exits leading
ok
northeast and southwest.
3149h, 2881m ex-sw
Crossing the Zaphar. (road)
Filling the firmament is a lattice of heavy grey clouds. You see exits leading
ok
northeast, west, and down.
3149h, 2881m ex-w
Nearing a river. (road)
Filling the firmament is a lattice of heavy grey clouds. You see exits leading
ok
east and south.
3149h, 2881m ex-s
Dirt road. (road)
Filling the firmament is a lattice of heavy grey clouds. You see exits leading
ok
north and south.
3149h, 2881m ex-s
Dirt road. (road)
Filling the firmament is a lattice of heavy grey clouds. You see exits leading
ok
north, south, and west.(last room of zone1)
NOTICE!!!!
3149h, 2881m ex-w
sw
Skirting the edge of Western Ithmia. (road)
Filling the firmament is a lattice of heavy grey clouds. You see exits leading
ok
east, south, and southwest.(first room of zone2)
3149h, 2881m ex-w
Now now, don't be so hasty!
Slow walking aborted
3149h, 2881m ex-w
There is no exit in that direction.
3149h, 2881m ex-There is no exit in that direction.
3149h, 2881m ex-Slow walking aborted

i use #sa ok, when i send #ok.

As you can see, everything is perfectly ok,
next walking command is sent after #ok is sent.

But when zone change occurs - i put NOTICE!!! there in the log i gave- You can see, that mapper is sending 2 directions at one time:w sw, but i still sent only 1 #ok. That means that mapper does #ok when it changes zone.

Now now, don't be so hasty! -message i get, when sw command being sent too fast after w from zone1. i use #stop #step on it, but as w commands proceeded to room1 of zone2, it sent #ok and next exit (w) was sent, so #step assumes that last commands is w, but it should be sw

Any suggestions? maybe there's some option to turn off sending #ok when changing zones?