Zugg Software :: View topic

Newbie Joined: 26 Feb 2002 Posts: 2

I have 6.16 zmud..
I tried to setup the 'exit config,' but it still does not seem workin..
for example..

The Pathway of Peace
This wide pathway leading through the heart of the elven city is covered
by many trees overhead that shade the road from the sun, and much of
any foul weather that may pop up from time to time. The inn of light can
be seen here to the east, while the pathway keeps going to the south and
ends at the Shrine to the north.
- North - East - South

The program reads the room name correctly..
> The Pathway of Peace

Somewhat correct description..
> This wide pathway leading through the heart of the elven city is covered
by many trees overhead that shade the road from the sun, and much of
any foul weather that may pop up from time to time. The inn of light can

Exits messed up..
> up from time to time. The inn of light can
be seen here to the east, while the pathway keeps going to the south and
ends at the Shrine to the north.

I know it should read this "- North - East - South" but it won't and therefore exit line drawings all over.
What can I do?

Apprentice Joined: 03 Jan 2002 Posts: 152 Location: USA

There's an option in map properties called "Exit line starts with:"

You can try entering the "-" before your exits into that box and be sure to put a check in the box there to tell it to look for that character.

Newbie Joined: 26 Feb 2002 Posts: 2

Yes! I played with those for a while and I figured those out! Thanks a lot!! =)