Register to post in forums, or Log in to your existing account
 

Play RetroMUD
Post new topic  Reply to topic     Home » Forums » CMUD General Discussion
Araadan
Wanderer


Joined: 07 Jun 2009
Posts: 65
PostPosted: Fri Mar 24, 2017 3:23 pm   

error in floating point value
 
I run the client and execute
Code:
#show %eval(1.0/2)

It's OK.

After several hours of starting, I am re-entering the code
Code:
#show %eval(1.0/2)


The program returns 0 and displays a big error window "error in floating point value".

I can not reset the program every hour.


Edit:
This solution works -> http://forums.zuggsoft.com/forums/viewtopic.php?t=22432
But with more advanced calculations, I can not handle syntax
Reply with quote
TechChris
Newbie


Joined: 03 Apr 2017
Posts: 1
Location: Phuket/Stockholm
PostPosted: Mon Apr 03, 2017 12:44 pm   
 
I was just about to post a question about a similar issue. Then i was going to ask here in your thread. Then i see you have edited the post and given an anwser. So i ended up saying thank you instead :) Thank you! /chris
Reply with quote
Display posts from previous:   
Post new topic   Reply to topic     Home » Forums » CMUD General Discussion All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

© 2009 Zugg Software. Hosted by Wolfpaw.net