charneus
Wizard
Joined: 19 Jun 2005
Posts: 1876
Location: California
|
 Posted: Thu May 05, 2011 12:41 am
[3.34]What would cause this?
|
I've recently installed CMUD on a fresh system, meaning CMUD was never on it before, etc.
I transferred my settings over via copy/paste (could have imported it to xml, but it's the same anyway). I have macros that utilize the function keys (f1-f12). All the macro does is run to a specified room within the macro.
Instead of doing that, however, it just displays the directions. The alias I use to run with is perfectly fine; I type 'rrun #' and it runs to that room. It's only when I use the function keys that it refuses to work.
So my question is, what would cause that? |
|
