Register to post in forums, or Log in to your existing account
 

Play RetroMUD
Post new topic  Reply to topic     Home » Forums » CMUD Beta Forum
ReedN
Wizard


Joined: 04 Jan 2006
Posts: 1279
Location: Portland, Oregon

PostPosted: Sat Sep 18, 2010 3:55 pm   

[3.27] %roomload using the room key instead of the vNum?
 
It says in the documentation that it takes vNum as the argument. However, I've found that if I give it the vNum it isn't looking up the right room. The only way to get it to give me the right room was to use %roomkey on the vNum to convert it to a Room Key.
Reply with quote
Zugg
MASTER


Joined: 25 Sep 2000
Posts: 23379
Location: Colorado, USA

PostPosted: Sat Sep 18, 2010 5:36 pm   
 
Check your %roommode. Remember that most of the %room functions take either the Roomkey or the vNum depending upon the %roommode setting.
Reply with quote
ReedN
Wizard


Joined: 04 Jan 2006
Posts: 1279
Location: Portland, Oregon

PostPosted: Sat Sep 18, 2010 5:47 pm   
 
Righto, apparently I still wasn't understanding that even after I'd read about it previously.
Reply with quote
Display posts from previous:   
Post new topic   Reply to topic     Home » Forums » CMUD Beta Forum All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

© 2009 Zugg Software. Hosted by Wolfpaw.net