 |
Guthaes
Newbie
Joined: 11 Jul 2010
Posts: 1
|
 Posted: Sun Jul 11, 2010 3:34 am
AutoMapper not working right after install
|
I downloaded and installed CMUD 2.37 today. I turned off ATCP, created a new map .mdb, and went through the automapper wizard. I found that when going through the wizard, the "MUD OUTPUT" pane was blank. Lo and behold, the mapper doesn't automap. Any suggestions?
|
|
|
|
|
Rahab
Wizard
Joined: 22 Mar 2007
Posts: 2320
|
Posted: Tue Jul 13, 2010 1:09 pm
|
What mud, and give us an example of the mud output for room descriptions, including the prompt before and the prompt before the output.
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
