 |
oldguy2
Wizard
Joined: 17 Jun 2006
Posts: 1201
|
 Posted: Sun Jun 28, 2009 4:22 am
Multistate Triggers Getting Stuck
|
What would cause your multistate triggers for no reason just stop working but then when you reload offline and test they work fine.
When I go online it gets stuck at like the 3rd state and then will never fire the trigger again period which means it causes a bunch of problems because it never sees the line and doesn't set a variable for another script that will just continue to run thinking nothing happened...
It's the same exact concept as this trigger
It has the trigger and 3 states. When I was online it stuck on the third state and never worked again after that. I have #state 0 in both the reparse conditions.
I'm at a loss as to why it isn't working. It always did before. I have some other triggers that have like a second state within 1 lines and do this too sometimes. If the second state doesn't show up they just stop working after that and that isn't what is supposed to happen at all. If the line after that trigger doesn't show up it should then reset.
Sooo what the heck is going on?  |
|
|
|
|
Rahab
Wizard
Joined: 22 Mar 2007
Posts: 2320
|
Posted: Sun Jun 28, 2009 3:20 pm
|
What version? If this is the beta, a bug has been reported on multitstate triggers.
If it's not the beta, you'll have to tell us exactly what the code is, I think. "Same concept" does not mean same code, and the code is tricky. |
|
|
|
|
oldguy2
Wizard
Joined: 17 Jun 2006
Posts: 1201
|
Posted: Sun Jun 28, 2009 9:49 pm
|
Never mind. I figured out the problem.
|
|
|
|
|
|
|
|
