Zugg Software :: View topic

Beginner Joined: 24 Nov 2005 Posts: 19

When i am in the mapper part of zmud and hold the mouse over a room, it is suppose to tell me the short name or whatever of the room (if I remember right), instead I get a DIVISION BY ZERO error. It doesn't lock up my system or anything but it happens EVERY TIME I do this. I tried downloading ZMAPPER to see if it'd fix it and it is doing the same thing. Any help would be great.

I am using the full versions of ZMUD and ZMAPPER and they are also the newest out. I am running windows XP pro with 1.5 gig of RAMBUS memory.

WHen I last played the mud, about 5-6 months ago, it was working fine. Now....not so much

Thanks in advance

GURU Joined: 23 Dec 2000 Posts: 4834 Location: USA

Does it do it for any room, or just specific ones? If it's the latter, then more than likely the mapper is working fine and you just have to remap the problem rooms.

Have you tried closing the mapper and/or the ZMud character so that ZMud is forced to reload everything? Sometimes, for practically no reason at all, the mapper just goes bonkers without really affecting the map itself. By reloading the mapper and map, you reset everything back to normal. Another trick might be to just compress the map, which will as far as I've seen cause the mapper to simply stop working and require you to close and reopen it.

Beginner Joined: 24 Nov 2005 Posts: 19

It does it for any room. It does it every time I run zmud or the map. Not quite sure how to reset everything and put it to normal though