 |
Silvanthos
Newbie
Joined: 12 Feb 2005
Posts: 1
Location: C.C. , Tx
|
 Posted: Sat Feb 12, 2005 8:10 pm
class not registered error
|
I am recieving a error after I installed the license code .. say's class not registered then zmud will get stuck and not load . I have the newest version 7.05 from the zugg site .. perhaps someone out there can help me .
|
|
|
|
|
MattLofton
GURU
Joined: 23 Dec 2000
Posts: 4834
Location: USA
|
Posted: Sat Feb 12, 2005 8:53 pm
|
Sounds like eLicense didn't install properly. You can try uninstalling again (be sure to get the elicense uninstaller) and reinstalling, but you might end up having to talk to eLicense themselves.
|
|
_________________
EDIT: I didn't like my old signature |
 |
|
|
Zugg
MASTER
Joined: 25 Sep 2000
Posts: 23379
Location: Colorado, USA
|
Posted: Sat Feb 12, 2005 11:52 pm
|
No, this isn't an eLicense problem. It's usually an ADO/MDAC problem.
The first thing to do is run the ZSCONVERT.EXE program and then exit it. This will register the ZsConvert class in case that didn't get registered during the installation.
If it still fails, then it's ADO/MDAC. Go to http://www.zuggsoft.com/data and follow the instructions given there. If you are using Windows XP, run the Windows Update and make sure all service packs and patches are installed. Sometimes the only way to fix this is to do a Reinstall of Windows from your original CD using the Repair option (and then reinstall all the patches).
And yeah, don't you just love these stupid Microsoft error messages that don't even bother to tell you *what* class isn't registered. This is one of the most useless error messages Windows gives and it's nearly impossible to totally figure out what the problem is. In many cases the software on the disk is fine and it's just the registry entries that are messed up, and many times their installers don't fix the registry entries. |
|
|
|
|
|
|
|
