Register to post in forums, or Log in to your existing account
 

This forum is locked: you cannot post, reply to, or edit topics.  This topic is locked: you cannot edit posts or make replies.     Home » Forums » zExplorer Discussion
Lila_AC
Newbie


Joined: 18 Jul 2004
Posts: 8

PostPosted: Thu Dec 09, 2004 6:27 am   

December 2004 calibration values
 
After calibrating for about an hour, here are the best values I've gotten so far.

Location: 006624F8
Offset: blank
Heading: 0068EB44
Direct: checked

You'll jump around a little bit, but nowhere near as bad as all the previous values I tried. Hopefully someone will find and post better values soon.

If it matters, these values were found on Morningthaw.
Reply with quote
Atros_HG
Newbie


Joined: 10 Dec 2004
Posts: 2

PostPosted: Fri Dec 10, 2004 12:44 am   
 
Thank you very much Lila!! Very Happy
Reply with quote
Davidge
Novice


Joined: 14 Apr 2004
Posts: 33
Location: Colorado

PostPosted: Fri Dec 10, 2004 8:17 am   
 
I found another set of values that seem to work on all the worlds that Ashikaga, D'sanai and I have tried so far.

No jumping around, but as usual its the camera, not your true loc. As such it will show your Z coord a tad higher than you.

Direct mode
Location: 00632E6C
Offset: <empty>
Heading: 0068EB44
Reply with quote
Atros_HG
Newbie


Joined: 10 Dec 2004
Posts: 2

PostPosted: Fri Dec 31, 2004 3:31 pm   
 
Thank you!! Razz
Reply with quote
Display posts from previous:   
This forum is locked: you cannot post, reply to, or edit topics.   This topic is locked: you cannot edit posts or make replies.     Home » Forums » zExplorer Discussion All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
© 2009 Zugg Software. Hosted on Wolfpaw.net