 |
Lorthan
Newbie
Joined: 26 Mar 2004
Posts: 2
Location: USA
|
 Posted: Fri Mar 26, 2004 8:14 pm
%w %1 trigger problems
|
ok, im trying to set up a trigger that pulls information from the mud then uses that information in a trigger that fires off. i tried following the example in the help files for an autoreply.
it says #TRIGGER {(%w) tells you} {tell %1 I am busy}
when i type that in it sets the trigger, but when someone sends me a tell it triggers EXACTLY:
tell %1 I am busy
it doesnt change the %1 to what the (%w) should be. im using version 7.04. do i have to some how set %1 to look for %w?
any help would be appriciated!
i will look through the forum more for the answer but havent seen it so far, if i do see it i will remove this note to clear clutter :) |
|
|
|
|
Danlo
Magician
Joined: 28 Nov 2003
Posts: 313
Location: Australia
|
Posted: Fri Mar 26, 2004 8:51 pm
|
It would look like you have changed the default Parameter char from a % into something else. Go to View, Preferences, Special Characters, and check that % is your active Parameter char.
|
|
|
|
|
Lorthan
Newbie
Joined: 26 Mar 2004
Posts: 2
Location: USA
|
Posted: Fri Mar 26, 2004 8:56 pm
|
DOH!!!! i remember changing that back in like version 4.62 ROFL. ok, i feel like a moron now. Thanks, that was driving me batty.
|
|
|
|
|
|
|
|
