Zugg Software :: View topic

Beginner Joined: 10 Aug 2002 Posts: 13 Location: USA

Found a bug when creating a new trigger / alias / etc...

1) Copy some text to the clipboard
2) Open a settings file
3) Click the Down arrow next to New and select New trigger
4) Single click the new trigger in the list view. This will put the Name field in Edit mode.
5) Press Ctrl-V on our keyboard

Result: The list view re-draws and your new trigger is gone.

New macro and new alias also do this.

Edit: Found an AV too. After creating a new trigger click an empty spot on the list box. Single click the new trigger and it will be highlighted. Wait a second and click again to put it in edit mode. When the entry goes into edit mode it will cause an AV after a couple of seconds:

---------------------------
zMUD
---------------------------
Access violation at address 006C88AB in module 'ZMUD.EXE'. Read of address 00000016.
---------------------------
OK
---------------------------

Click OK and the new trigger disappears.

GURU Joined: 10 Oct 2000 Posts: 4379 Location: USA

Confirmed first bug, but couldn't reproduce the second one.

Although Zugg may be reading the posts in the General Forum since the public version was just released, be sure to e-mail this to him directly so you make sure that it gets entered into the bug database.

Wizard Joined: 14 Oct 2000 Posts: 1368

quote:
Originally posted by Kjata

Confirmed first bug, but couldn't reproduce the second one.

Although Zugg may be reading the posts in the General Forum since the public version was just released, be sure to e-mail this to him directly so you make sure that it gets entered into the bug database.

I have actually posted a link to this post in the beta forum Smile

Posted: Wed Feb 18, 2004 7:32 pm

When the list view has the keyboard focus, the Copy/Paste are going to copy and paste full triggers or other settings and not just the text name field. You need to click in the editor panel into the Name field and use paste there.