 |
Darkspawn
Beginner
Joined: 18 Sep 2002
Posts: 15
|
 Posted: Tue Sep 23, 2003 6:41 pm
Manual Config of Automapper?
|
Ok So I play on a mud where the automapper for some reason does not capture the information at all in auto config. However, I am able to configure my prompt in the mud so that it shows both the room name and exits(i don't care about room description).It looks something like this
<100/100hp 100/100m 100/100mv> Room: Dragon Tower Exits: NSEW
Is there a way to set the automapper to capture the room name and exits from my prompt and make a map from there? Thanks for the help. |
|
|
|
|
Talahaski
Enchanter
Joined: 10 Oct 2000
Posts: 656
Location: USA
|
Posted: Tue Sep 23, 2003 7:14 pm
|
Take a look at the #Tag command in the help file. Its a bit complicated, but I think the help file does a good job of explaining it.
|
|
|
|
|
Darkspawn
Beginner
Joined: 18 Sep 2002
Posts: 15
|
Posted: Tue Sep 23, 2003 8:39 pm
|
Thanks that seems straightforward enough...but once I write the appropriate #tag trigger for the name and exits, how do I use the automapper?
|
|
|
|
|
Talahaski
Enchanter
Joined: 10 Oct 2000
Posts: 656
Location: USA
|
Posted: Tue Sep 23, 2003 8:49 pm
|
After creating the tag triggers, re-run the auto map configuration wizard. Then you should be all set you start mapping.
|
|
|
|
|
|
|
|
