Alok
Newbie
Joined: 14 Jun 2003
Posts: 7
Location: Namibia
|
 Posted: Sun Jun 29, 2003 5:01 pm
Gemstone automapping
|
I'm having a bit of trouble with the Auto Config on Gemstone (one of Simutronics's games). When I try and go into Map Creation mode (after doing the Auto Config), I get an error that says:
RoomRS: Cannot perform this operation on a closed dataset.
The error comes up every time output comes from the MUD, even something like someone entering the room. Since the MUD is kinda busy, I get this error multiplying quite a bit.
Here's what a typical room in this MUD looks like:
[Wehnimer's, Land's End Rd.]
Vigilant guardsmen scrutinize the citizens and travelers arriving and departing through the wide gateway spanning the land route into Wehnimer's Landing. The frenetic pace of the city to the south is a far cry from the deceptive calm of the wilds of Elanith outside. Two daunting towers survey the countryside and protect the town, flanking the road to the east and west. You also see a wooden barrel.
Obvious paths: south
The room title (In the []) is highlighted via Gemstone's GSL scripts already. When I configure, it highlights nothing.
~Alok |
|
