|
Daussaulit Newbie
Joined: 25 Feb 2001 Posts: 7 Location: USA
|
Posted: Wed Nov 19, 2003 9:26 am
Capture windows infinite loop problem |
I just tried to load settings that I used to have with 6.16 into 6.16. Zmud starts up fine, but when I try to connect to the profile the capture windows I have set up start popping up like normal, except for one, it just keeps making the same capture window over and over and over. It doesn't respond and then I'll have to end task from the task manager. They're tabbed. So after zmud starts up, the main window opens, than the tabbed a,b,c, and d come up normally, but once window e opens up, it'll just open it again and again, eventually all the tabs fill up with just folder E and then I'm locked out of zmud. Its looping or something. Anyone know what the problem is?
|
|
|
|
shalimar GURU
Joined: 04 Aug 2002 Posts: 4672 Location: Pensacola, FL, USA
|
Posted: Wed Nov 19, 2003 9:29 am |
I'm not sure what it is, but i expierenced the same problem in 6.62 when i had a saved layout but told zmud not to use it... eventually it would stop making the child windows and i could close all the excess windows
|
|
|
|
Cuttlefish Apprentice
Joined: 28 Oct 2003 Posts: 164
|
Posted: Wed Nov 19, 2003 4:52 pm |
Sure are a lot of people using 6.16. Try upgrading and see if it's fixed in the current version.
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|