Zugg Software :: View topic

Newbie Joined: 08 Jan 2013 Posts: 5

I just realized I posted this to Zmud forum when I meant to post to Cmud...sorry about that. Reposting here.

Hi,

I'm trying to create a file that is a series of commands that includes directions and actions. I'd love to be able to basically "replay" part of my mud session at a later date. Histsave and Histload would be perfect, if they also captured directions. I can't figure out an easy way to capture my commands (with directions) during play. I don't want the mud's output, because I want to be able to re-enter them later. Any ideas?

An example might be:

n
open n
l man
l woman
s
e
open n
dance
put gem in pot
l pot

Basically, I play a mud that gives points for "exploring" areas, with each character. So, after I explore an area once I want to be able to efficiently explore it again with my next character by re-entering the all the commands needed to walk and explore the area.

Thanks in advance.

Sorcerer Joined: 15 Apr 2011 Posts: 809

You can make a command input trigger that fires on everything and write it to a file. Off the top of my head, untested:

GURU Joined: 23 Dec 2000 Posts: 4834 Location: USA

Check out the Preferences. There's a preference that lets you specify the minimum length of characters a command must be in order to be saved in command history.

Posted: Tue Jan 08, 2013 10:58 pm

you could make you own log of commands with #FILE #WRITE and an #ONINPUT trigger

Newbie Joined: 08 Jan 2013 Posts: 5

Just wanted to update this thread too (since I accidentally started one here and one on Zmud)...

Thanks all for the good suggestions. Matt's super simple solution worked though...so I'm all set!!